Have currently got the standard Greddy setup so oil feed and oil drain going to the inlet side of the block. As I'm sorting the cracked manifold I thought now was a good time to sort this out.
A few questions!
I googled the block thread size for the oil feed and I came up with conflicting information. I read it should be either m10x1.5 OR is it 3AN?
The oil feed pipe I have has the oil pressure guage size thread. What size is this?
Have also read of various sizes of oil drain in the sump 3/8 or 1/2?? Which is best for the greddy turbo?
Thanks
Scott
A few questions!
I googled the block thread size for the oil feed and I came up with conflicting information. I read it should be either m10x1.5 OR is it 3AN?
The oil feed pipe I have has the oil pressure guage size thread. What size is this?
Have also read of various sizes of oil drain in the sump 3/8 or 1/2?? Which is best for the greddy turbo?
Thanks
Scott
