Adz - Viewing Profile: Posts - MX5Nutz Forum

Jump to content

These ads only show for users who are not registered or logged in


Adz

Member Since 05 Jan 2011
Offline Last Active Jun 29 2020 10:13 PM
-----

Posts I've Made

In Topic: Nc Manifold Fitting - Advice For An Inexperienced Diyer Please

22 June 2020 - 04:45 PM

With the BBR one you ditch an O2 sensor? With the IL one apparently both need to be moved?

In Topic: Gaz Gold Knock. Is This Right??

13 June 2020 - 08:17 PM

looks like you've got race dampers with metal spherical bearings as opposed to rubber bushes like the more road-focused makes youve mentioned?

this applies to the lower & upper mounts, spherical bearings (called 'pillow-ball' mounts by some - usually japaneese sellers) can wear & have minor play or movement that causes knocking or banging - not shopping car friendly [emoji38]

not all's lost though, they can be replaced easily & cheaply, possibly with rubber if you're not needing the metal bearing precision of racecar :confused:

Rich.

Oh brill thanks for your reply Rich!

Do GAZ sell the rubber bushes? Can I push them in on the car or do they need to be pressed in and out?



Sent from my PCT-L29 using Tapatalk

In Topic: Nc Owners Spoilt For Choice.....

17 May 2020 - 12:19 PM

Bit of a thread revival! 

Did the Cosworth kit ever get kinda sorted out? I notice Flyin Miata were tracking one a while back so did they get around the intake temp thing? 

Also the new CM charger I notice doesn't replace the intake manifold so is the intake temp less of an issue?